Quick Startup - Canon imageRUNNER ADVANCE C5500 Series Service Manual

Quick Startup

To realize faster startup, power configuration has been changed to always supply power to the AC Driver PCB and Main Controller
PCB. Consequently, the Touch Panel can be operated after 4 seconds from turning ON the Main Power Switch.
Even when the Main Power Supply Switch is OFF, power is supplied to the following PCBs:
AC Driver PCB
5 V All-night Power Supply
Main Controller PCB
NOTE:
The quick startup function can be set from "Settings/Registration".
• Settings/Registration > Preferences > Timer/Energy Settings > Quick Startup Settings for Main Power
[On]: Quick startup is executed (default)
[Off]: Quick startup is not executed
Disconnect the power plug when performing work with the possibility to come in contact with the PCBs above. If a conductive
material comes in contact with the PCB, short circuit may occur in the PCB, and may cause damage on it.
The following label is used at the place where attention is required.
In addition, quick startup is not performed under the following conditions.
Under the following conditions (settings), the machine always starts up normally (even if quick startup is enabled).
Either of the following devices is connected:
The coin vendor is connected.
Network (under Settings/Registration > Preferences > Network)
TCP/IP Settings > IPSec Settings > Use IPSec is set to ON.
TCP/IP Settings > IPv6 Settings > Use IPv6 is set to ON.
AppleTalk Settings > Use AppleTalk is set to ON.
Right after the machine is shut down under the following conditions, it starts up in normal mode (even if quick startup is ON).
Fax-related information
There is a fax transmission reservation.
Within a specified period of time (10 seconds) from disconnection of a fax line.
Within a specified period of time (10 seconds) from non-detection of reception from a fax line.
Within a specified period of time (10 seconds) from putting down the fax sub device or handset
MEAP-related Information
During execution of an MEAP application which prohibits entering Deep Sleep
A scheduled processing is reserved on MEAP.
Job processing-related information
A job is being executed/in standby (Print/Copy/Send/Fax/Report/Forwarding/Storage processing, etc.)
During fax communication/phone communication
During distribution of device information
During export/import by RUI
A file is being opened/read/written in Access Stored Files > Network (common to SMB/WebDAV)
Others
Accumulated time during which the machine is powered on as well as powered off (with quick startup turned ON) is 110 hours or
more.
Within a specified period of time (20 seconds) from turning OFF the Main Power Supply Switch
Quick startup setting ON
Power is supplied
Power is supplied
Power is supplied
Quick Start
At first startup after the power plug is connected to the outlet
Plug Off
159
2. Technology
Quick startup setting OFF
Power is supplied
OFF
OFF