Removing The Developing Unit - Canon imageRUNNER ADVANCE C5500 Series Service Manual

2. Align the guide [1] of the Developing Unit with the guide [2] of the Drum Unit, and install the Drum Unit [3].
[2]
[1]
CAUTION:
Be sure to check that the shutter [2] slides along the rail [1] and is located in the correct position as shown in the figure
below to prevent the rail [1] from being damaged.
3. Hold down each of the 8 grips [1] lightly with a finger to check that the Drum Units [2] are installed properly.
CAUTION:
Actions after Replacement:"Actions after Parts Replacement" on page 436

Removing the Developing Unit

■ Preparation
1. Pulling out the Process
2. Removing the Drum Unit"Removing the Drum Unit" on page 325
[2]
[1]
Unit"Pulling out the Process Unit" on page 317
[3]
[2]
[1]
[1]
[2]
328
4. Disassembly/Assembly
[2]
[1]