Geometric Characteristics Adjustment - Canon imageRUNNER ADVANCE C5500 Series Service Manual

7. Output and check that the margin is within the standard values.
■ Software adjustment
Use the following service mode to make an adjustment.
1. Leading edge
Service Mode > COPIER > ADJUST > FEED-ADJ >
Service Mode Items
REGIST
REG-DUP1
REG-THCK
REG-DUP2
As the input value is changed by 1, the margin on the leading edge of paper is changed by 0.1 mm.
2. Left edge
Service Mode > COPIER > ADJUST > FEED-ADJ >
Service Mode Items
ADJ-C1
ADJ-C1RE
ADJ-C2
ADJ-C2RE
ADJ-C3
ADJ-C3RE
ADJ-C4
ADJ-C4RE
ADJ-MF
ADJ-MFRE
As the input value is changed by 1, the margin on the left edge of paper is changed by 0.1 mm.
3. If the service mode setting value has been changed, write down the new adjustment value on the service label.
<Reference: Standard value>
Leading edge: 4.0+1.5/-1.0 mm (front side, back side)
Left edge: 2.5+/-1.5 mm (front side)/2.5+/-2.0 mm (back side)

Geometric Characteristics Adjustment

Geometric characteristics adjustment is executed when image distortion (on the entire image and the trailing edge only) occurs.
The following 3 adjustments are available as the geometric characteristics adjustment.
1. Pre-secondary transfer guide adjustment
2. Registration pressure adjustment
Feeding direction
- +
Description of adjustment
1/1 speed
1/1 speed, 2nd
1/2 speed
1/2 speed, 2nd
Description of adjustment
Cassette 1, front side
Cassette 1, back side
Cassette 2, front side
Cassette 2, back side
Cassette 3, front side
Cassette 3, back side
Cassette 4, front side
Cassette 4, back side
Multi-purpose Tray, front side
Multi-purpose Tray, back side
COPIER>ADJUST>FEED-ADJ
ADJ-xx/ADJ-xxRE
xx = C1/C2/C3/C4/MF
+
-
410
5. Adjustment