Removing The Machine From The Pallet; Lubricating The Machine - Toro GreensPro 1260 Operator's Manual

1. Locking pin
2. Latch
7. Step on the hitch pedal until the hitch locks into
place (Figure 8).
8. Insert the locking pin through the holes in the
latch (Figure 8).
9. Torque the lug nuts on the transport wheels to
108 N∙m (80 ft-lb).
3
Removing the Machine
from the Pallet
No Parts Required
Procedure
1. Remove the wood blocks at the hitch end of the
pallet.
Figure 8
3. Hitch pedal
1. Wood blocks
2. Place some wood boards on the ground at the
end of the pallet.
Note:
The height of the wood boards should be
g279746
slightly lower than the pallet. You can use pieces
removed from the sides and/or ends of the crate.
3. Carefully roll the machine off the pallet, onto the
wood boards, and then to the ground.
Important:
contact the pallet as the machine drops to
the ground.
4. Remove any remaining packaging.
4

Lubricating the Machine

Parts needed for this procedure:
–
Lubricants (not included)
Procedure
Before you operate the machine, lubricate it to ensure
proper operating characteristics; refer to
the Drive-Roller Bearing (page
lubricate the machine will result in premature failure
of critical parts.
10
Figure 9
Ensure that the rollers do not
23). Failure to properly
g024330
Lubricating