Maintenance
Note:
Download a free copy of the electrical or hydraulic schematic by visiting www.Toro.com and searching
for your machine from the Manuals link on the home page.
Maintenance Safety
•
Before you leave the operator's position, do the
following:
– Park the machine on a level surface.
– Move the throttle lever to the idle position.
– Ensure that the motion pedals are in neutral
position.
– Engage the parking brake.
– Shut off the engine.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
After the first 5 hours
After the first 20 hours
Before each use or daily
After each use
Every 50 hours
Every 100 hours
Every 300 hours
Every 400 hours
Important:
Refer to your engine owner's manual for additional maintenance procedures.
Maintenance Procedure
• Check the machine for any loose hardware.
• Change the engine oil.
• Change the hydraulic fluid and filter.
• Change the hydraulic fluid and filter.
• Lubricate the drive-roller bearing.
• Check the engine-oil level.
• Check the air cleaner.
• Check the air cleaner.
• Check the safety-interlock system.
• Check the parking brake.
• Check the hydraulic hoses and fittings.
• Check the hydraulic-fluid level.
• Check the tire air pressure in the transport wheels.
• Check the machine for any loose hardware.
• Clean the machine.
• Clean the air cleaner (more often in dirty or dusty conditions).
• Change the engine oil.
• Check/adjust the spark plug.
• Clean the sediment cup.
• Replace the paper element.
• Replace the spark plug.
• Check and adjust the valve clearance.
• Change the hydraulic fluid and filter.
• Change the hydraulic fluid and filter.
– Wait for all moving parts to stop.
– Allow the machine to cool before adjusting,
servicing, or cleaning.
•
If possible, do not perform maintenance while the
engine is running. Keep away from moving parts.
•
Use jack stands to support the machine or
components when required.
•
Carefully release pressure from components with
stored energy.
20