Electrical System Maintenance; Checking The Safety-Interlock System; Brake Maintenance; Checking The Parking Brake - Toro GreensPro 1260 Operator's Manual

Electrical System
Maintenance
Checking the
Safety-Interlock System
CAUTION
If the safety-interlock switches are
disconnected or damaged, the machine could
operate unexpectedly, causing personal
injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock
switches daily, and replace any damaged
switches before operating the machine.
Important:
If the safety-interlock system does not
operate as described below, have an authorized
Toro distributor repair it immediately.
1. If on the transport wheels, lower the machine
onto the rollers; refer to
the Rollers (page
2. Engage the parking brake, ensure that the
motion pedals are in the
start the engine.
3. Sit on the seat.
4. With the parking brake engaged, gently press a
motion pedal down; the engine should shut off
after approximately 1 second.
5. With the engine running and the brake
disengaged, stand up and verify that the engine
shuts off after 1 second.
Note:
The safety-interlock system is also designed
to shut off the engine if the operator rises off the seat
while the machine is moving.
Lower the Machine onto
18).
position, and
NEUTRAL

Brake Maintenance

Checking the Parking Brake

Service Interval: Before each use or daily
1. Drive or transport the machine to a level surface.
2. If you transport the machine, disconnect it from
the tow vehicle and lower the machine onto
the rollers; refer to
from the Tow Vehicle (page 18)
Machine onto the Rollers (page
3. Engage the parking brake.
4. Start the engine and set the engine speed to
I .
DLE
5. Sit on the operator's seat.
6. Press one of the motion pedals.
Important:
The machine should not move.
If it moves, adjust the parking brake; refer to
Adjusting the Parking Brake (page
Note:
The engine shuts off in 1 second when
you press the motion pedal with the parking
brake engaged.
Adjusting the Parking
Brake
1. Ensure that the engine is shut off.
2. Release the parking brake.
3. Adjust the parking brake as follows:
•
To increase the brake force, rotate the brake
locknut clockwise
•
To decrease the brake force, rotate the brake
locknut counterclockwise
29
Disconnecting the Machine
and Lower the
18).
29).
(Figure 34).
(Figure 34).