Installing The Transport Wheels; Installing The Hitch Assembly - Toro GreensPro 1260 Operator's Manual

1
Installing the Transport
Wheels
Parts needed for this procedure:
2 Transport wheel
Removing the Shipping Brackets
1. Remove the lug nuts securing the wheel hubs to
the shipping bracket
1. Lug nut
2. Lag bolt
2. Remove the other lug nut threaded onto the
wheel-hub stud (Figure
3. Remove the lag bolts that secure the shipping
brackets to the pallet, and remove the bracket
(Figure 3).
4. Repeat steps 1 through
bracket at the other side of the machine.
Installing the Wheels
1. Loosely assemble the 2 transport wheels onto
the wheel hubs with the lug nuts that you
removed in Removing the Shipping Brackets
(page 8).
Note:
You will torque the lug nuts at the end of
2 Installing the Hitch Assembly (page
2. Adjust the tire air pressure to 103 kPa (15 psi).
(Figure 3).
Figure 3
3. Shipping bracket
3).
3 for the shipping
8).
2
Installing the Hitch
Assembly
Parts needed for this procedure:
1 Lock bracket
4 Bolt (M10 x 30 mm)
4 Lock washer (M10)
6 Washer (M10)
4 Nut (M10)
1 Hitch assembly
1 Bolt (M10 x 100 mm)
1 Locknut (M10)
1 Bolt (M12 x 100 mm)
2 Washer (M12)
1 Locknut (M12)
2 Spacer washer (when applicable)
Procedure
1. Install the lock bracket to the frame of the
machine as shown in
Note:
Torque the nuts to 52 N∙m (38 ft-lb).
g279735
1. Bolt—M10 x 30 mm (4)
2. Lock washer—M10 (4)
3. Washer—M10 (4)
2. Secure the hitch to the hitch pivot bracket with
the appropriate hardware; refer to
8
Figure 4.
Figure 4
4. Nut—M10 (4)
5. Lock bracket
Figure
g036890
5.