Toro GreensPro 1260 Operator's Manual page 33

1. Filter head
3. Carefully remove the hydraulic filter
4. Fill the replacement filter with the specified
hydraulic fluid and lubricate the sealing gasket
with hydraulic fluid.
5. Install the filter onto the filter head by hand
(Figure 37) until the gasket contacts the filter
head, then tighten the filter 3/4 turn further.
6. Wipe up any spilled hydraulic fluid.
7. Dispose of the old filter according to local codes.
Filling the Hydraulic Reservoir
1. Lower the machine onto the rollers; refer to
Lower the Machine onto the Rollers (page
2. Remove the hydraulic-reservoir cap
3. Fill the reservoir with the specified hydraulic
fluid; refer to Hydraulic Fluid Specification (page
31) and Checking the Hydraulic-Fluid Level
(page 31).
4. Install the reservoir cap
5. Wipe up any spilled hydraulic fluid.
Figure 37
2. Hydraulic filter
(Figure
(Figure
Figure 38
(Figure 38).
6. Start the engine and run it at low idle for 3 to 5
minutes.
Running the engine circulates the hydraulic fluid
and removes air trapped in the hydraulic system.
7. Check the machine for hydraulic leaks at the
reservoir, hydraulic hoses, and the hydraulic
filter.
Repair all hydraulic leaks.
8. Shut off the engine, check the hydraulic-fluid
level, and add fluid if necessary.
9. Lower the operator's seat; refer to
Operator's Seat (page
g279901
37).
18).
38).
g279900
33
Lowering the
23).