Mitsubishi Electric MELSEC iQ-R Series User Manual page 39

Parameter settings
Perform the initial settings in the module parameters and wave output data creation of the engineering tool. The auto refresh
setting does not need to be changed here.
■Module parameter
Set the module parameters as follows.
Function Setting item
Range switching function Output range setting
Operation mode setting Operation mode setting
function
Output mode setting function Analog output HOLD/CLEAR setting
D/A conversion enable/disable D/A conversion enable/disable setting
setting function
Scaling function Scaling enable/disable setting
Scaling upper limit value
Scaling lower limit value
Shift function Input value shift amount
Warning output function Warning output setting
Warning output upper limit value
Warning output lower limit value
Rate control function Rate control enable/disable setting
Increase digital limit value
Decrease digital limit value
Operating procedure
1.
Set the window as follows to create the project.
[Project]  [New]
2.
Click the [Setting Change] button and set the module to use the module label.
3.
Click the [OK] button in the following window to add the module label of the CPU module.
CH1 CH2
-10 to 10V 4 to 20mA
Wave output mode (20s/CH)
HOLD CLEAR
D/A conversion D/A conversion
disable disable
Disable Disable
 
 
0 0
Enable Disable
32000 

0
Disable Disable
 
 
7.3 Program Example (for Wave Output Mode)
CH3 CH4
4 to 20mA 4 to 20mA
CLEAR CLEAR
D/A conversion D/A conversion
disable disable
Disable Disable
 
 
0 0
Disable Disable
 
 
Disable Disable
 
 
7 OPERATION EXAMPLES
7
37