Mitsubishi Electric FR-A800 Series Beginner's Manual page 11

Operation
WARNING:
P
● When you have chosen the retry function, stay away from the equipment as it will restart
suddenly after an alarm stop.
● Since pressing the
provide a circuit and switch separately to make an emergency stop (power off, mechanical
brake operation for emergency stop, etc).
● Make sure that the start signal is off before resetting the inverter alarm. A failure to do so
may restart the motor suddenly.
● Do not use a PM motor for an application where the PM motor is driven by its load and runs
at a speed higher than the maximum motor speed.
● Performing pre-excitation (LX signal and X13 signal) under torque control (Real sensorless
vector control) may start the motor running at a low speed even when the start command
(STF or STR) is not input The motor may run also at a low speed when the speed limit value =
0 with a start command input. It must be confirmed that the motor running will not cause
any safety problem before performing pre-excitation.
● The inverter can be started and stopped via the serial port communications link or the field
bus. However, please note that depending on the settings of the communications parame-
ters it may not be possible to stop the system via these connections if there is an error in the
communications system or the data line. In configurations like this it is thus essential to
install additional safety hardware that makes it possible to stop the system in an emergency
(e.g. controller inhibit via control signal, external motor contactor etc). Clear and unambig-
uous warnings about this must be posted on site for the operating and service staff.
● Use this inverter only with three-phase induction motors or with a PM motor. Connection of
any other electrical equipment to the inverter output may damage the inverter as well as the
equipment.
● Do not modify the equipment.
● Do not perform parts removal which is not instructed in this manual. Doing so may lead to
fault or damage of the inverter.
Frequency Inverters - Beginner's Guide
key may not stop output depending on the function setting status,
VII