Cmu Protect Mode Setting; Cmu Alarm Led Clear; Cmu User Err Led Clear; Cmu Ip Address Setting - Hitachi CMU Series User Manual

4.2.3 CMU PROTECT MODE setting

Set whether to run the task in protection mode or not.
Writing from the task to SEQ-RAM is disabled while the task is running in protection mode.
Click the ON button to let the task run in protection mode.
Click the OFF button to let the task run in non-protection mode.

4.2.4 CMU ALARM LED clear

Clears the CMU module's ALARM LED, which starts glowing when an error that is not serious
enough to disrupt the CMU module's operation is detected or when a "battery not connected" or a
"battery low" condition is detected in the presence of the "battery connected" setting selected.

4.2.5 CMU USER ERR LED clear

Clears the CMU module USER LED, which glows when an invalid user setting is detected.

4.2.6 CMU IP address setting

(1) [Set CMU IP Address] window
The [Set CMU IP Address] window opens, prompting you to set the IP address, subnet mask,
broadcast address, and route for the CMU's built-in Ethernet device. To validate the
information setup, restart the PCs. You must also make sure that the CMU rotary switches
are both set to "0".
• "IP Address" box
Specifies the IP address.
• "Subnet Mask" box
Specifies the subnet mask.
• "Broadcast Address" box
4-11
4 OPERATION