Table of Contents
Advertisement
4 OPERATION
4.7 Register Module Information
Set the CPU module LADDER switch from STOP to RUN to start data transmission. The state
of transmission in progress can be verified by viewing the LINK LED light on the CPU link
module's front-panel.
• For the location of the LINK LED, see "2.1 Names and Functions of Each Part."
• RUN has two modes of operation: normal (NORM) and simulation (SIMU) (use the CPU
module's MODE switch to perform setup for the S10mini). Either mode setting enables the
CPU link module to transmit.
The settings entered in "4.6 Setting Module Information" are loaded into the CPU (or LPU) link
module when the LADDER switch is set from STOP to RUN or when the CPU is reset.
Whenever a new setting is made (or the existing setting is changed), be sure to set the LADDER
switch from STOP to RUN or reset the CPU (or LPU).
4-16
Advertisement
Table of Contents
