Hitachi LQE550 User Manual page 63

4 OPERATION
<Notes on installing in Windows® 7 (32-bit)>
Installing the S10V CPU LINK system in Windows® 7 (32-bit) operating system requires
prior logging onto the operating system with an appropriate Administrator account, which
is the Administrator account first created in the initial condition of your personal computer.
When you have so logged on, you can then double-click "setup.exe" that is stored in the
DISK 1 folder on the S10V CPU LINK System CD. When "setup.exe" is started, the
dialog box as shown below will appear. Click the
execution of the setup program.
The S10V CPU LINK system cannot be installed on a per-user basis. To install
the S10V CPU LINK system successfully, the user must first log onto the
operating system with an appropriate Administrator account, which is the
Administrator account first created in the initial condition of your personal
computer.
The S10V CPU LINK system may not be installed properly in any of the following
cases: 1) administrator permission is acquired by using User Account Control(*)
with a standard user account and 2) logon is made with an Administrator account
that has been created using User Account Control with a standard user account.
If you make a logon with a user account that is different from the one you have
used for the installation of the S10V CPU LINK system, the installed program
may be missing from the program menu displayed. In this case, you should
perform the following series of steps: 1) make a logon again with the
Administrator account first created in the initial condition of your personal
computer; 2) uninstall the installed program; and 3) install the program again.
When you want to create a new account, be sure to make a logon with an
Administrator account. Do not use User Account Control at that time.
(*) User Account Control is a Microsoft Windows feature that temporarily grants
administrative rights to standard user accounts.
A message reporting a read-only file detected may be displayed during the reinstallation of
the S10V CPU LINK system. In this case, click the
Yes
Yes
4-18
button to continue the
button to set off overwriting.