Advertisement
IMPORTANT:
To mount multiple devices in the rack, place the heaviest one at the bottom of the rack.
Unpacking the router
Unpack the router as shown in
Figure 4 Unpacking the router
Packing belt
Installing the router in a 19-inch rack
Before you install the router to a rack, wear an ESD-preventive wrist strap. For how to wear an
ESD-preventive wrist strap, see
The HSR6602-G is used as an example in this section.
To install the router in a rack:
1.
Mark the positions of cage nuts on the front rack posts by using a front mounting bracket and mark
the positions of cage nuts on the rear rack posts by using a rear mounting bracket. See
Figure 5 Marking the positions of the cage nuts
2.
Insert one edge of a cage nut into the hole, and use a flat-blade screwdriver to compress the other
edge of the cage nut to push the cage nut fully into the hole.
Figure
4.
Foam brace
"ESD
prevention." The HSR6600 Routers are installed in the same way.
9
Figure
5.
Advertisement
