Table of Contents
Advertisement
Figure 19
1. Turn-signal switch
2. Steering-wheel valve
7
Installing the Horn
Parts needed for this procedure:
1
Horn assembly
1
90° bracket
1
Flange-head screw (5/16 x 3/4 inch)
1
Flange locknut (5/16)
Procedure
1. Remove the nut and 90° bracket from the horn
assembly
(Figure
20).
Figure 20
1. Horn
2. 90° bracket
3. Hose clamp
3. Nut
2. Rotate the 90° bracket as shown in
loosely secure it to the mounting stud of the horn
assembly with the nut that you removed in step 1.
Note: You will tighten the nut of the horn assemble
in a later procedure.
3. Align the hole in the short leg of the 90° bracket with
the hole in the rear-platform channel
4. Assemble the 90° bracket to the platform channel with
the flange-head screw (5/16 x 3/4 inch) and the flange
locknut (5/16) as shown in
1. Horn assembly
2. Flange-head screw (5/16
x 3/4 inch)
5. Torque the flange-head screw and flange locknut to
198 to 254∙N∙m(175 to 225 in-lb).
11
Figure 20
(Figure
Figure
21.
Figure 21
3. Flange locknut (5/16)
and
21).
Advertisement
Table of Contents
