Toro 41250 Installation Instructions Manual page 26

Replacing a Tail-light Bulb
1. Ensure that the light switch is in the O
2. Remove the 2 screws that secure the cover and lens
to the tail-light base.
3. Remove the tail-light cover.
4. Pushing down on the pin on the light bulb, rotate the
light bulb to the left, and pull the light bulb out
70).
Figure 70
1. Pin
5. Insert the new light bulb into the hole where the old
light bulb was removed from.
6. Rotate the new light bulb to the right until the pin of
bulb aligns with the slot in the light-bulb casing
70).
7. Install the tail-light cover with the 2 screws.
position.
FF
(Figure
2. Light bulb
(Figure
Replacing a License Plate Bulb
1. Remove the 2 screws that secure the cover to the base
of the license-plate light, and remove the cover (A of
Figure 71).
1. Screw
2. Cover
3. Light base
2. Push down the bulb slightly and rotate it
counterclockwise until it is unlocked from the light
socket, and remove the bulb (B of
3. Insert the new light bulb into the bulb socket (B of
Figure 71).
4. Press down the bulb slightly and rotate it clockwise
until the bulb locks into the socket (B of
5. Align the cover to the base of the license-plate light
with the lens down (A of
6. Secure the lens to the base with the 2 screws that you
removed in step 1.
26
Figure 71
4. Lens
5. Bulb
6. Light socket
Figure 71).
Figure
Figure 71).
71).