2. Align the lens for the light down and the holes in the
light with the holes in the license-plate bracket
41).
1. License-plate light
2. Locknut (#10)
3. Assemble the light to the bracket
screws (#10 x 5/8 inch) and 2 locknuts (#10).
Note: Ensure that the wires are not pinched between
the light and the license-plate bracket.
11
Installing the Hazard Switch
Parts needed for this procedure:
1
Hazard switch
Procedure
1. Remove the hole plug for the hazard switch from the
control panel on the side-console mount
Figure 41
3. Screw (#10 x 5/8 inch)
4. License-plate bracket
(Figure
41) with the 2
(Figure
(Figure
1. Hole plug
2. Route the 8-socket connector of the wire harness
through the hole in the side-console mount
1. 8-socket connector
3. Connect the 8-socket connector of the wire harness to
the 8-blade connector of the hazard switch
42).
1. 8-socket connector
18
Figure 42
2. Side-console mount
(Figure
Figure 43
2. Hole in the side-console
mount
(Figure
Figure 44
2. Hazard switch (8-blade
connector)
43).
44).