Table of Contents
Advertisement
8. Fully insert the clevis pin through the holes in the seat
latch and the inboard-seat gusset.
9. Secure the lock bracket to the outboard-seat gusset
with the hex-head screw (12 x 20 mm) and the locknut
(12 mm) as shown in
1. Hex-head screw (12 x 30
mm)
2. Lock bracket
15
Installing the Seat
No Parts Required
Procedure
1. Ensure that the grip of the lock-mount bracket and the
latch is facing up
(Figure
Note: If the grip is not in the right position, put a
screw driver into the slot of the latch and rotate the
grip upward.
1. Lock-mount bracket
2. Latch
2. Align the seat and seat pan with the holes in the
machine frame where the seat was removed
Figure
60.
Figure 60
3. Outboard-seat gusset
4. Locknut (12 mm)
61).
Figure 61
3. Grip
(Figure
1. Seat and seat pan
3. Insert the 2 pivot pins that secure the seat and seat pan
to the chassis
1. Hairpin
2. Pivot fitting (seat pan)
3. Chassis bracket
4. Insert the 2 hairpins that secure the pivot fitting of the
seat pan to the chassis brackets
5. Connect the electrical connector of the chassis harness
to the seat-switch connector
1. Connector (chassis
harness)
62).
6. Lower the seat and latch it to the seat pan.
23
Figure 62
(Figure
63).
Figure 63
4. Pivot pin
5. Seat pan
(Figure
(Figure
64).
Figure 64
2. Seat-switch connector
63).
Advertisement
Table of Contents
