Operation METPOINT® BDL portable
12.3.2.4 Calibrating the touch screen
Main menu Settings Calibration touch screen
12.3.2.4.1 Brightness
Main menu Settings Brightness
Note: at the first touch, the
Afterwards, "normal" functional operation is possible again.
Important: when the
Darken-after
currently set brightness.
60
brightness
in our example is reset to 50%.
button is not activated, the backlighting is continuously on, at the
If required, the screen calibration can be
changed here.
Press
Calibrate,
and a calibration cross will
appear 1. on the upper left, 2. on the lower
right, and 3. in the middle. These crosses must
be pressed consecutively.
When calibration is completed and the indica-
tion is averaged, confirm with OK.
If this is not the case, calibration can be re-
peated by means of
Cancel
Calibrate
again.
Here, the desired
brightness
(15 ... 100%) of the display can directly be
set.
E.g.:
brightness
to 50%.
By means of the
Darken-after
brightness
can be reduced to a minimum at
the end of a time interval to be defined (here
after 15 minutes), or completely switched off.
In addition, in order to preserve battery life,
the display backlight can be completely
switched off by means of the
button at the end of the defined time interval
(here after 45 minutes)
As soon as the dimmed screen is activated
again, the
brightness
automatically goes back
to the value that was last set prior to dimming.
and by pressing
button, the
Backlight off after
®
METPOINT
BDL portable