Configuration Of Analogue Sensors; Types 0 - 1/10/30 Volt And 0/4 - 20 Ma - Beko METPOINT BDL portable Instructions For Installation And Operation Manual

12.3.2.3.1.2 Configuration of analogue sensors

Short overview of the possible
Auswahl des Sensortyps (Beispiel Typ BEKO-Digital Sensor)
and 7.3.2.1.2.6 Taupunktsensor mit dem Typ
The alarm settings, recording
and value name are all described in Chapter
For the marking of the text fields, see Chapter
12.3.2.3.1.3 Types 0 - 1/10/30 Volt and 0/4 – 20 mA
Main menu  Settings  Sensor settings  C1  Type text field  0 - 1/10/30 V
Main menu  Settings  Sensor settings  C1  Right arrow (2
®
METPOINT BDL portable
Type settings including examples. For BEKO-Digital,
BEKO-Digital.
buttons, the resolution
7.3.2.1.2
7.3.2.1.2.7 Textfelder beschriften und
125.44 °C
Operation METPOINT® BDL portable
of the decimal places as well as the
Sensor-Einstellung.
Scaling of the sensor (here, for example,
0 – 10 V - corresponds to 0 – 250°C) can be
found in the data sheet of the connected
sensor.
nd
page)
For scal. 0 V, please enter the lower scale
value and for scal. 10 V
ue.
The ext. sensor supply voltage
when the sensor type requires this.
Please confirm with OK.
With the Set-value-to
measured data of the sensor can be set to a
certain value.
The positive or negative difference of the
offset is indicated.
With the reset button, the
to zero.
see Chapters 7.3.2.1.2.1
short name
einstellen!
type
the upper scale val-
is switched on
button (offset), the
offset can be reset
37