Initial Setting - Mitsubishi Electric Melsec Q Series User Manual

5 UTILITY PACKAGE (GX Configurator-AD)

5.4 Initial Setting

5 - 14
[Purpose]
The following A/D initial setting parameters are set:
• A/D conversion enable/disable setting
• Averaging process setting
• Time/number of times specifying
• Average time/average number of times setting
Setting parameters in the Initial setting screen will not required parameter settings
with sequence program.
[Operating procedure]
1
"Start I/O No. "
1: Enter the start I/O No. in hexadecimal.
[Setting screen]
[Explanation of items]
(1) Setting contents
Set whether A/D conversion is enabled or disabled and the A/D conversion
method for each channel.
(2) Command buttons
Make text file
End setup
Cancel
POINT
Initial settings are stored in the intelligent function module parameter. After being
written to the CPU module, the initial setting is made effective by either (1) or (2).
(1) Cycle the RUN/STOP switch of the CPU module: STOP
RUN.
(2) With the RUN/STOP switch set to RUN, turn off and then on the power or
reset the CPU module.
When using a sequence program, the initial setting parameters are written at the
time the CPU module status changes from STOP to RUN. So, create the sequence
program so that the initial setting will be reexecuted.
"Module type" "Module model name"
Creates a file containing the screen data in text file format.
Saves the setting data and ends the operation.
Cancels the setting and ends the operation.
MELSEC-Q
Initial setting
RUN STOP
5 - 14