Removing A 2.5 Inch Disk; Removing A 3.5 Inch Disk; Locate Cage Dialog Box - HP 3PAR StoreServ 7450 Service Manual

4. In the Locate Cage dialog box, enter an appropriate time to allow service personnel to view
the LED status of the Drive Enclosure (Cage). See
NOTE:
Figure 36 Locate Cage Dialog Box
An icon with a flashing LED will be shown next to the cage, which flashes all drives in this
cage except the failed drive.

Removing a 2.5 inch Disk

1. Pinch the handle latch to release the handle into open position.
2. Pull the handle away from the enclosure and wait 30 seconds.
3. Slowly slide the disk drive out of the enclosure and set aside
4. Remove the replacement disk drive from its packaging. To reinstall a new disk drive, see
"Installing a Disk Drive" (page
Figure 37 Removing a 2.5 inch Disk

Removing a 3.5 inch Disk

To remove a 3.5 inch disk drive:
1. Pinch the latch in the handle towards the hinge to release the handle.
2. Gently pull the disk drive out approximately one inch and wait 30 seconds.
3. Slide the disk drive out of the enclosure and set aside.
If necessary, use the Stop Locate icon to halt LED flashing.
36).
Figure 36 (page 35).
Repairing a Disk Drive 35