Adding A Storage System To The Service Processor - HP 3PAR StoreServ 7450 Service Manual

(y or n)
y
5. When the installation process completes, the SPMaint main menu reappears. To verify the
current software versions after installation, type 1 for SP Control/Status.
1
1
6. Type 1 for Display SP Version to verify installation is complete.
1.1
SP-2.5.1.GA-15
SP Base Image Version:
SP Version:
SP Patches:
InFormOS release (3.1.2):
More detail is available in the latest SPLOR or spconfig data.
Press <enter/return> to continue
Continue to "Adding a Storage System to the Service Processor" (page

Adding a Storage System to the Service Processor

After successfully completing the Service Processor Setup Wizard, you must add the storage system
to the configuration database of the SP. Adding the storage system permits the SP to communicate,
service, and monitor the health of the system.
To add the storage system to the SP:
1. Connect the maintenance PC to the SP.
2. In the SPMaint, type 3 and press Enter to select StoreServ Configuration Management.
SPXXXXX
tpdSPInFormOS3.1.2.226-3.1.2.226-12.i386.rpm
Do You wish to update the SP from /mnt/cdrom?
SP Main
3PAR Service Processor Menu
Transfer media: ethernet
Enter Control-C at any time to abort this process
1 ==> SP Control/Status
2 ==> Network Configuration
3 ==> StoreServ Configuration Management
4 ==> StoreServ Product Maintenance
5 ==> Local Notification Configuration
6 ==> Site Authentication Key Manipulation
7 ==> Interactive CLI for a StoreServ
X Exit
Display SP Version
SP Software Version
1 SP Main
Transfer status: Ok
3.1-8
2.5.1.GA-15
3.1.2.226
Adding a Storage System to the Service Processor
55).
55