Port Details - HP 3PAR StoreServ 7450 Service Manual

-
1:1:1 target
-
1:1:2 target
-
1:2:1 initiator loss_sync 2FF70002AC0185A6 21210002AC0185A6
-
1:2:2 initiator loss_sync 2FF70002AC0185A6 21220002AC0185A6
-
1:2:3 initiator loss_sync 2FF70002AC0185A6 21230002AC0185A6
-
1:2:4 initiator loss_sync 2FF70002AC0185A6 21240002AC0185A6
-
1:3:1 peer
RCIP1 -
showport -sfp to verify that the replaced SFP is connected and the State is listed as
OK:
cli% showport -sfp
N:S:P -State- -Manufacturer- MaxSpeed(Gbps) TXDisable TXFault RXLoss DDM
0:1:1 OK
0:1:2 OK
0:2:1 OK
0:2:2 OK
1:1:1 OK
1:1:2 OK
1:2:1 OK
1:2:2 OK
1:2:3 OK
1:2:4 OK
Open the HP 3PAR Management Console
1. Under the Systems tree in the left panel, select the storage system to be serviced to connect.
2. On the Summary tab, click the Port link to open the port's tab.
3. Verify that State is listed as Loss Sync, the Mode is listed as Initiator, and the Connected
Device Type is listed as Free.
Figure 44 Port details
4. Contact HP Support for further verification.
44 Servicing the Storage System
-
ready 2FF70002AC0185A6 21110002AC0185A6 host
-
ready 2FF70002AC0185A6 21120002AC0185A6 host
-
-
-
-
-
offline
-
HP-F
HP-F
AVAGO
AVAGO
HP-F
HP-F
HP-F
HP-F
HP-F
HP-F
- 0002AC8004BD
8.5 No
8.5 No
10.3 No
10.3 No
8.5 No
8.5 No
8.5 No
8.5 No
8.5 No
8.5 No
FC -
FC -
free FC -
free FC -
free FC -
free FC -
rcip IP
No No Yes
No No Yes
No Yes Yes
No Yes Yes
No No Yes
No No Yes
No Yes Yes
No Yes Yes
No Yes Yes
No Yes Yes