HP 9000 Manual page 31

3. Close the Disk Space confirmation window to see the analysis
4. When the disk analysis is satisfactory, choose OK on the Install
5. A confirmation screen will appear, to which you can respond Yes or No
NOTE Note that, up to this time, you can "back out" of any action by clicking on
Cancel in order to return to previous screens, for example, in order to
adjust the selection of filesets being updated.
6. You will see a second confirmation screen warning you that a new
7. You will see an install status screen which monitors the current
8. If you want to keep track of the progress of messages and scripts
Time Note • A typical HP-UX update, if done from a network server, will require
• At the end of an HP-UX update, you will see a confirmation message
• As the system reboots for the first time, configure scripts run for the
After Logging In 1. The login screen appears after the system has rebooted. Log in at this
2. Check the following log files for any messages, including warnings,
Chapter 2
window.
Analysis screen to proceed with the update.
as to whether you want to continue with the installation.
kernel will be loaded (in case you are updating HP-UX or a
kernel-related patch bundle), and this will necessitate a reboot.
Respond Yes, if you wish to go ahead.
progress of the installation, including the time remaining.
being run during the load, you can keep a logfile window open during
the process. Do this by clicking on the Logfile button, on the status
screen.
one to two hours.
and reboot warning (with about 30 seconds delay until shut down).
new filesets so you can expect a first boot time of several minutes.
Subsequent reboot processes will not take as long.
time.
relating to the update:
/var/adm/sw/swinstall.log
/var/adm/sw/swagent.log
Updating an Existing Operating System and Software
Updating HP-UX Software
31