Configuring an Ignite-UX Server
Ignite-UX Distribution Media
Network Requirements.
If you are loading your server depots or client software from a remote
system, your target system also will need the following:
• A network card. If the target system has multiple LAN cards, select
the card that is configured onto the correct network using Ignite-UX
→ System Tab → Additional Interfaces.
Only one LAN card is used during the installation, configured on the
client console or handled automatically by the bootsys utility.
Your server system will need to be configured. In addition you will need
the following:
• The server system must be on the same network subnet as the target
(client) system that will be installed. Or you will need a "helper"
system on each subnet from which to boot clients.
• A functional network connection. If you have more than one LAN
connection, be prepared to select the correct one with which to
connect to the install server system.
Note: You can only boot over the network from an Ethernet interface.
FDDI is also supported, but for non-booting only.
66
Chapter 4