HP 9000 Manual page 84

Installing from the Ignite-UX Server
Network Source Installation
Command
-------
Auto [boot|search] [on|off]
Boot [pri|alt|scsi.addr] [isl]
Boot lan[.lan_addr] [install] [isl] Boot from LAN
Chassis [on|off]
Diagnostic [on|off]
Fastboot [on|off]
Help
Information
LanAddress
Monitor [type]
Path [pri|alt] [lan.id|SCSI.addr]
Pim [hpmc|toc|lpmc]
Search [ipl] [scsi|lan [install]]
Secure [on|off]
------------------------------------------------------------------------
BOOT_ADMIN>
• If your network only has one Ignite-UX server available, type the
• Otherwise, to make sure you boot from the correct server, do one of
a. To search for servers type the following (Series 700 only):
b. The list of servers will be displayed with IP addresses. You may
c. Once you know the IP address of your server (as provided by the
84
Description
Display or set auto flag
Boot from primary,alternate or SCSI
Enable chassis codes
Enable/disable diagnostic boot mode
Display or set fast boot flag
Display the command menu
Display system information
Display LAN station addresses
Select monitor type
Change boot path
Display PIM info
Display potential boot device
Display or set security mode
following:
boot lan install
the following:
• Make the system search for servers and pick one. OR
• Explicitly tell the system where to boot, as follows:
search lan install
need to run the command nslookup on another running system to
determine which address corresponds to your Ignite-UX server, if
this information isn't already available.
search, or by the nslookup command), boot the system by typing
the following:
boot lan.nn.n.nn.n install
For nn.n.nn.n, supply the IP address of your server.
The system then begins to load the install kernel from the
network server.
Chapter 5