Functions Available On All Tabs - HP 9000 Manual

Installing from the Ignite-UX Server
Configuring the Installation
HP-UX can have more than one installed language. The "default
language" is the language environment represented on the target system
at boot, unless you select another installed language using the HP-VUE
or CDE login screen, reset the LANG environment variable, or use
geocustoms (HP-UX 10.30) to change it.
Default Language By clicking on Default Language ... you have displayed the Default
Choices
Language Choices. They are listed in two columns: Language and Locale.
Each language may have more than one way of representing itself on the
system. If this is the case, there will be multiple locale entries for the
same language.
Languages may be activated is several ways:
• ASK_AT_FIRST_BOOT allows you to leave the language setting open
• SET_NULL_LOCALE creates a NULL language environment, with the
Select the type of keyboard to be used, from the adjacent field.
Keyboards...
Otherwise, you can use the default selection.
Additional... This button brings up a screen allowing you to select among certain
pre-configured use-models and variables from your current configuration
files. The buttons which are available will be determined from the
variables in your config file. When using LVM, you will see selections for
easily setting up multiple disks, striping, and file system creation. For
details on setting this up, see the instl_adm(4) man page.

Functions Available on all Tabs

In server mode, when you have finished your configuration for all tabs,
Save As...
you can save the configuration as a specific file. The saved configurations
will then appear under the Configurations menu for use in future
installations. This function is not available if you are running the
Ignite-UX interface on the install client.
94
(unset) until the client system is first booted. At that time, the
language setting will be performed as part of the initial system
configuration. (This applies only to HP-UX 10.30 and later).
locale variables set to NULL by default. A null locale allows programs
to execute without using localized message catalogs. This can
increase system performance. All HP-UX messages appear in English
if the locale is set to NULL.
Chapter 5