Table of Contents
Advertisement
Wiper/Washer Switch
The wiper and the window washer are operated using the
wiper/washer switch.
Wiper
Turn the wiper/washer switch to the specified position to
operate the wiper.
OFF
The wiper stops and is retracted.
INT Position
The wiper operates intermittently at the
interval selected by the switch position as
described below. INT has three positions of
operating speed as shown below.
INT (Slow): The wiper operates at 8-second interval.
INT (Mid):
The wiper operates at 6-second interval.
INT (Fast):
The wiper operates at 3-second interval.
ON
The wiper operates continuously.
f
NOTE: When the front window (upper) is opened, the wiper
and washer will not operate. If the front window is opened
while operating the wiper, the wiper stops.
Washer
Press and hold the wiper/washer switch to squirt washer
fluid onto the front window. When the wiper/washer switch
is pressed for more than 2 seconds, the wiper operates until
the switch is released. When the wiper/washer switch is
released, the wiper automatically retracts.
While operating the wiper in the INT mode, when the
wiper/washer switch is pressed, the wiper operation mode
is changed to the continuous operation mode.
f
NOTE: The wiper motor protection control stops wiper
operation to prevent it from becoming immovable when
it operates long period of time under high load. When the
wiper stops, do not change the arm position and wait several
minutes until the wiper starts operating again.
OPERATOR'S STATION
1-92
Middle
Slow
Fast
MBFM-01-005
Wiper
M1U1-01-018
Advertisement
Table of Contents
