Table of Contents
Advertisement
3. At this time, do not remove the inner element.
IMPORTANT: Do not hit or clash outer element (1) against
other object to clean the element.
4. Allow compressed air pressure [less than 0.69 MPa (7
kgf/cm
)] to blow out of the inside of outer element (1)
2
to clean the element. After that, blow compressed air
along the pleats, and then blow out from the inside.
When blowing compressed air, be sure to keep the air
nozzle 50 mm or away from the element.
5. After cleaning is complete, be sure to check outer
element (1) for any damage such as holes or worn of
filter paper. If any damage is found, replace the element
with new one.
6. Press outer element (1) into the air cleaner body
straightly by hand. Ensure that outer element (1) is
properly installed by pushing its bottom edge.
7. Install cover and tighten clamps (2).
8. In case the air filter restriction indicator lights soon after
cleaning outer element (1) even if the cleaning times are
less than 6 times, replace both outer and inner elements
with new ones.
IMPORTANT: Do not install outer element (1) and/or the
cover forcibly when installing the clamps. Failure to do
so may result in deformation of clamps (2), element,
and/or cover.
MAINTENANCE
MJAE-07-059
7-67
2
ZX135US-5B
ZX225US-5B, 225USLC-5B
1
ZX135US-5B
1
ZX225US-5B, 225USLC-5B
MDCN-07-035
2
MDCN-07-036
MDCN-07-038
MDCN-07-039
Advertisement
Table of Contents
