Removal And Replacement Procedures For Authorized Service Provider Parts; Component Replacement Procedures; Thermal Material - HP OMEN X Maintenance And Service Manual

6 Removal and replacement procedures for
authorized service provider parts
IMPORTANT:
provider. Accessing these parts can damage the computer or void the warranty.
NOTE: HP continually improves and changes product parts. For complete and current information on
supported parts for your computer, go to http://partsurfer.hp.com, select your country or region, and then
follow the on-screen instructions.

Component replacement procedures

There are as many as 52 screws that must be removed, replaced, or loosened when servicing the computer.
Make special note of each screw size and location during removal and replacement.

Thermal material

Table 6-1 Thermal material description and part number
Description
Liquid metal thermal material
Thermal material must be applied on site, and therefore is not included in component spare part kits. When
removing any part that also requires removal of the heat sink, be sure to order and apply thermal material.
Affected parts are shown in the following list:
● Power button board cable
● Touchpad cable
● Heat sink
IR sensor board
●
IR sensor board cable
●
Second display panel
●
System board
●
Top cover with keyboard
●
Components described in this chapter should be accessed only by an authorized service
Spare part number
L65923-001
Component replacement procedures 31