Network Connector Door - HP OMEN X Maintenance And Service Manual

Network connector door

Table 6-8 Network connector door description and part number
Description
Network connector door
Before removing the network connector door, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the solid-state drive (see
5. Remove the heat sink/fan assembly (see
6. Remove the second display transfer board (see
7. Remove the power connector board and bracket (see
8. Remove the system board (see
Remove the network connector door:
From the removed system board, lift the back of the door (1), and then remove the door from the
▲
computer (2).
Reverse this procedure to install the network connector door.
44 Chapter 6 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
Bottom cover on page
Battery and speakers on page
Solid-state drive and Optane Memory Module on page
Heat sink/fan assembly on page
Second display transfer board on page
System board on page
26).
27).
32).
35).
Power connector cable on page
41).
Spare part number
L57023-001
29).
38).
39).