Display Assembly - HP OMEN X Maintenance And Service Manual

Display assembly

NOTE: Spare parts for the display assembly are available only at the subcomponent level.
Before removing the display assembly, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Remove the battery and speakers (see
4. Remove the heat sink/fan (see
5. Remove the second display transfer board (see
6. Remove the power connector board and bracket (see
7. Remove the system board (see
Remove the display assembly:
1. Remove the wireless antenna cables from the clips in the computer chassis (1).
2. Remove the three Phillips M2.5 × 4.5 screws (2) from each hinge.
3. Open the display to 90º (3).
4. Separate the display from the computer (4).
5. If it is necessary to replace display assembly subcomponents, first remove the bezel:
a. Release the top edge of the display bezel (1) from the display assembly.
IMPORTANT:
b. Release the left and right edges of the display bezel (2) from the display assembly.
c. Release the bottom edge of the display bezel (3) from the display assembly.
(Preparation for disassembly on page
Bottom cover on page
Battery and speakers on page
Heat sink/fan assembly on page
System board on page
Be careful not to bend or break the narrow sections of the bezel when removing.
27).
32).
35).
Second display transfer board on page
Power connector cable on page
41).
Component replacement procedures
26).
38).
39).
51