Device Setup; Where To Place The Device; Supplying Ac Power To The Device - Philips DreamStation 2 User Manual

3. Device setup

Where to place the device

Place the device on a firm, flat surface somewhere within easy reach of where you will use it
at a level lower than your sleeping position. Make sure the device is away from any heating
or cooling equipment (e.g., forced air vents, radiators, air conditioners).
Note: When positioning the device, make sure that the power cable is accessible
because removing power is the only way to turn off the device.
Cautions
• Make sure the air inlet (slotted) area on the side of the device is not blocked by bedding,
curtains, or other items. Air must flow freely around the device for the system to work
properly.
• Do not place the device directly onto carpet, fabric, or other flammable materials.
• Do not place the device in or on any container that can collect or hold water.

Supplying AC power to the device

Warning: Periodically inspect electrical cords and cables for damage or signs of
wear. Discontinue use and replace if damaged.
Caution: Do not use extension cords with this device.
Complete the following steps to operate the device using AC power and refer to the
following images for guidance:
1. Ensure that the humidifier tank is empty.
2. Plug the power supply cord's connector into the power inlet on the bottom of the
device 1 or
For convenience, the power connection allows for the cord to connect and route in the
direction that works best for your setup.
An inset area on the bottom of the device allows the cord to be routed under the
3
device .
- 14 -
2 .