Huawei SmartACBox-12/1-JP User Manual page 61

SmartACBox 12-In 1-Out Smart AC Combiner Box
User Manual
LCD
----End
Issue 03 (2018-05-15) Copyright © Huawei Technologies Co., Ltd.
Operation Procedure
3. Enter the User name and Password by
pressing or , and then press
NOTE

Because of the limited permission, select the
User name as Advanced User. The initial
password for Advanced User is 000001.
 After passing the permission validation, the
system keeps the authentication information for
30 seconds. If you exit the screen and log in
again within 30 seconds, no authentication is
required.
4. Select Comm. Param. and press
5. Press , select NetEco, and press
6. Set NetEco parameters, and then press
NOTE
 Port number: If Huawei NMS is connected, set
this parameter to 16100 by default. If a
third-party NMS is connected, set this
parameter to the number of the service port
opened by the system.
 Set Address mode to Comm. address or
Logical address. If the devices connected to the
three RS485 ports of the SmartLogger1000
have duplicate addresses, you must set Address
mode to Logical address.
6 Operation
.
.
.
.
55