CHAPTER 7 CONNECTIONS
7.2
Transmission Cable Terminal Block
Manufacturer: PHOENIX CONTACT GmbH & Co. KG (Contact: www.phoenixcontact.com)
Model: MSTB 2,5/5-STF-5.08AU
Tightening torque: 0.2 to 0.3Nm
To tighten the connector, a flathead screwdriver having a tipped size of 0.4 2.5mm is required.
Before removing the transmission cable terminal block, check that the terminal block mounting screws on the both
sides are completely loosened (removed from the socket).
Pulling the terminal block with excessive force while the terminal block mounting screws on the both sides are still
tightened may damage the devices.
Before tightening the terminal block, check that there are no short circuits due to the disconnected or frayed wires.
Then tighten the terminal block mounting screws on the both sides securely. (Tightening torque: 0.2 to 0.3Nm)
7
53