Input is output by the FROM instruction, and output is output by the TO instruction.
A user program is added between the FROM and TO instructions.
The correspondence between each signal and the device in the program above is as shown below.
Input (1024 points)
Output (1024 points)
Error address information
Add a user program here.
Signal type
CHAPTER 4 PROGRAMMING
Reads inputs to
X100 to X4FF
Reads error address
information
Outputs Y100 to Y4FF.
Automatic address
detection
Corresponding device
X100 to X4FF
Y100 to Y4FF
D3000 to D3128
4
47