Operator Instructions; Cleaning Of The Cabinet; Service Inspection Of The Cabinet - ABB Terra 54 User And Operation Manual

4

Operator Instructions

4.1

Cleaning of the cabinet

The charger cabinet is made from powder coated, high quality stainless steel. The
coating must be kept in good condition.
Clean the charger three times a year in the following way:
Remove rough dirt by rinsing with low-pressure tap water.
•
• Apply a neutral or weak alkaline cleaning solution and let it soak.
• Remove dirt by hand with a non-woven nylon hand pad.
• Rinse thoroughly with tap water.
• Optionally, apply wax on the front for extra protection and gloss.
• Check the coating on damage.
4.2

Service inspection of the cabinet

The following points must be checked regularly:
• Internal RCDs and RCBOs need to be tested on correct functioning on a regular
basis. During the yearly maintenance visit, a check is advised, to be executed by a
certified ABB technician.
• Cable and connector
• Display screen
Powder coating
•
2 021 -01 -11
DANGER
Electrical components
• Do not apply high-pressure water jets. Water may leak
into the charge station.
• Only use cleaning agents with a pH value between 6
and 8.
• Do not use cleaning agents with abrasive components.
• Do not use abrasive tools.
NOTICE
Rust forming
When the charger is placed in a corrosion sensitive
environment, the forming of superficial rust is possible on the
welding points. This rust is merely visual, there is no risk for
the cabinet's integrity. The rust can be removed with the
cleaning procedure described above. To prevent the rust from
reappearing; prime the areas with a transparent or color-like
priming finish (separate Service Instructions are available).
→ Check for cracks or ruptures on the connector or cable, check whether no
internal wires of the cable are visible.
→ Check for damage and cracks.
→ Look for damage, cracks or ruptures.
T ERR A 5 4 / 5 4HV CHAR GER
1 7/26