Table of Contents
Advertisement
Notation Conventions
This manual uses the following notational conventions:
Term or Value
Active High Signals
(Logic One)
Active Low Signals
(Logic Zero)
Hexadecimal Values
Decimal Values
Binary Values
Blue Text
Bold
Definitions, Acronyms, and Abbreviations
Definitions, acronyms and abbreviations for terms used in this document are defined
below for reference.References
A/D
Analog to Digital
D/A
Digital to Analog
DSP
Digital Signal Processor or Digital Signal Processing
EVM
Evaluation Module
GPIO
General Purpose Input and Output Port on Motorola's Family of DSPs
IC
Integrated Circuit
JTAG
Joint Test Action Group. A bus protocol/interface used for test and
debug.
LQFP
Low profile Quad Flat Pack
viii
Symbol
No special symbol
attached to the signal
name
Noted with an
overbar in text and in
most figures
Begin with a "$" sym-
bol
No special symbol
attached to the
number
Begin with the letter
"b" attached to the
number
Linkable on-line
Reference sources,
paths, emphasis
DSP56F801EVM Hardware User's Manual
Examples
A0
CLKO
WE
OE
$0FF0
$80
10
34
b1010
b0011
...refer to
Chapter
7,
License
...see:
http://www.mot.com/SP
...
S/DSP
Exceptions
In schematic drawings,
Active Low Signals may
be noted by a back-
slash: /WE
Advertisement
Table of Contents
