NEC Express5800 Series User Manual page 110

Chapter 3 Setup
Option
Serial Port B Settings
Serial Port B
Serial B Base I/O
Serial B Interrupt
Console Redirection Settings
BIOS Redirection Port
Terminal Type
Baud Rate
Data Bits
Parity
Stop Bits
Flow Control
Continue C.R. after POST
Note
110
Parameter
–
Disabled Enable or disable serial Port B.
[Enabled]
3F8h Specify the base I/O address for serial port B.
[2F8h]
3E8h
2E8h
IRQ 4
Specify the interrupt for serial port B.
[IRQ 3]
–
[Disabled] Specifying a setting other than Disabled enables direct
connections using the NEC ESMPRO Manager or hyper
Serial Port B
terminal from the specified serial port. If this feature is
enabled, the following setting menu items are displayed.
[VT100+] Select the terminal type.
VT-UTF8
ANSI
9600 Specify the baud rate used for the interface with the
connected hardware console.
19200
57600
[115200]
7 Specify the data bit width.
[8]
[None] Specify the parity bits.
Even
Odd
[1]
Specify stop bits
2
None
Specify the flow control method.
[Hardware RTS/CTS]
Disabled Specify whether to continue the console redirection
[Enabled] function after POST processing.
Parameters for Serial Ports A and B are contained in NEC ESMPRO Manager, Online
BMC Configuration Tool, and EXPRESSSCOPE Engine 3. However, setting for Serial Port
A is not reflected because this server does not have serial port A
Express5800/B120d, B110d User's Guide
2. Details of System BIOS
Descriptions
–
–
[ ]: Factory settings