NEC Express5800 Series User Manual page 87
Hide thumbs
Also See for Express5800 Series:
- User manual (574 pages) ,
- Maintenance manual (238 pages) ,
- Installation manual (75 pages)
Table of Contents
Advertisement
Chapter 3 Setup
3.
POST displays several types of message. These messages let you know that the installed CPU or connected
keyboard and mouse are detected.
Tips
4.
After a while, POST displays the following message.
Press <F2> SETUP, <F3> Internal flash memory, <F4> ROM Utility, <F12> Network
By pressing the designated function key following messages, you can call the functions below upon
completion of POST.
<F2> key:
<F3> key:
<F4> key:
<F12> key:
Note
5.
If a controller which has its dedicated BIOS such as a SCSI controller board is installed, a message that prompts
you to start the dedicated utility to set each board is displayed.
Example: SCSI BIOS Setup utility
Press <Ctrl> <A> for SCSISelect(TM) Utility!
The utility starts by pressing the <Ctrl> + <A> keys.
Example: If an optional RAID Controller is installed
Press <Ctrl> <H> for Web BIOS
The utility starts by pressing the <Ctrl> + <H> keys.
Depending on the installed PCI card configuration, the memory capacity might be
displayed less than actually installed physical memory. (This applies to the display of
BIOS Setup utility or OS system information.)
Run the SETUP. For information on the SETUP, refer to Chapter 3 (2 Details of
System BIOS.).
Run EXPRESSBUILDER from Internal Flash Memory (optional). For information on
EXPRESSBUILDER, refer to Chapter 3 (4. EXPRESSBUILDER).
Run the offline tool. For information on the offline tool, refer to Chapter 1 Maintenance
(9. Offline Tools) in "Maintenance Guide".
Boot from network.
If the optional Internal Flash Memory is not installed in the system, the <F3> key
message will not be displayed.
The <F3> key must be pressed within 5 seconds of the message being displayed.
Note that the server will not boot from the Internal Flash Memory even if it is specified
to do so by pressing the <F3> key, as long as a bootable CD/DVD-ROM is set on the
drive with the boot priority of CD/DVD-ROM is set to higher than Solid State Drive.
Express5800/B120d, B110d User's Guide
1. Power-on of Blade Server
87
Advertisement
Table of Contents
