Snapshot Mode
Level/Presentation/Auto-Aim Trigger Mode Procedure
The system is initialized as follows:
•
The host sends the Aim Off command.
•
The host sends the Illumination Off command.
•
The host sends the Acquisition Stop command.
•
The host sends the Imaging mode command.
•
The SE4750 optimizes the image output for image capture.
•
The SE4750 (typically) enters low power mode.
Upon a trigger pull:
•
The host sends the Illumination On command.
•
The SE4750, if in low power mode, exits low power mode (either Reduced or Sleep).
•
The host sends the Aim On command.
•
The host sends the Acquisition Start command.
•
The SE4750 captures an image.
Upon completion of an image capture:
•
The SE4750 stops outputting image.
•
The host sends the Acquisition Stop command.
•
The host sends the Aim Off command.
•
The host sends the Illumination Off command.
•
The host goes back to Normal Decode Mode.
•
The SE4750 (when all conditions are met) enters Reduced Power mode.
Application Notes
6 - 9