Siemens SIMATIC RTU3041C Manual page 64

3 Useful Information
Configurable events
In addition to the configured update cycle, the RTU switches from sleep mode to
update mode when configurable events occur. You can configure the following
events:
–
Value change at analog input "AI0"
–
Edge change at a digital input
–
Triggering timers of program blocks (e.g., with the pulse generator or with
the on/off delay).
Figure 3-2: Parameterization of the additional update mode
Note Note that monitoring configured events will result in higher power consumption.
Monitoring of Remote Measurement Points
Entry ID: 109739240, V3.0, 06/2021
64