Toshiba G7 Series Applications Workbook page 32

Introduction
The G7 allows the user to customize the main display of the drive to show the drives output in a
variety of user defined units. This procedure will outline the procedure for changing the units
displayed.
Programming
Parameter
Enable User Defined Unit
User Defined Units
Hz Per User Defined Unit
Frequency Display Resolution
Note 1: The user may select up to eight characters to represent their units. Characters may be any
upper or lower case letter, 0-9 or any of the following special characters.
SPACE !
' (
. /
? @
`
To change units, move the selection box to the first position under user defined units and press the
dial or hit enter. Now rotate the dial until the desired character is displayed and press the dial or hit
enter again. Continue until all characters for the desired unit are displayed.
You do not need to change the characters in any particular order, and any character may be edited at
any time.
Note 2: Hz per user defined units is the conversion factor between Hz and the user defined units. In
most cases, this will have to be determined depending on the unit, the application, etc.
E.G.: The user wants to run a 4 pole motor using the drive and display the output in RPM. Using the
formula
So the Hz per user defined unit should be set to 30.
For additional assistance, please contact Toshiba Adjustable Speed Drive Marketing Dept. at (800) 872-2192
efesotomasyon.com -Toshiba inverter,drive,servo,plc
Customizing Display Units
Location
Utility Parameters → Display Units →
Enable User Defined Unit
Utility Parameters→Display Units→User
Defined Unit
Utility Parameters→Display Units→Hz
Per User Defined Unit
Utility
Units→Frequency Display Resolution
" #
) *
: ;
[ +/-
=
Rpm Hz *
Parameters→Display
$ %
+ ,
< =
] ^
120 120
= =
* 1 30
# poles 4
10
New Value
Checked
See Note 1 below
See Note 2 Below
See Note 3 Below
&
-
>
_
32