If the LCD or LED keypad is selected, the Local / Remote key is enabled to select either the
Keypad (local) or the Control Terminal Strip (remote) as the command source.
If the Control Terminal Strip (remote) is selected, it may be programmed to select any of the following
as a source of the command signal:
• Use RR (Factory Default)
• Use LED Keypad (option)
• Use Common (TTL)
• Use RS232/485
• Use Communication Card (option)
Frequency Mode #1
Direct Access Number – F004
Parameter Type – Selection List
Factory Default – Use RR
Changeable During Run – No
The Frequency Mode #1 determines the source of the frequency command or the torque command
(when operating in the torque control mode) of the G7.
If the LCD or LED keypad is selected, the Local / Remote key is enabled to select either the
Keypad (local) or the Control Terminal Strip (remote) as the command source.
Selections are
• Use Vi/II
• Use RR
• Use RX
• Use RX2 (Option Card)
•
Use LED Keypad (option)
•
Use Binary/BCD Input
•
Use LCD Keypad
•
Use RS232/485
•
Use Communication Card (Option)
•
Use MOP Function Simulation
•
Use Pulse Input Option
Frequency Mode #2
Direct Access Number – F207
Parameter Type – Selection List
Factory Default – VI/II
Changeable During Run – Yes
For additional assistance, please contact Toshiba Adjustable Speed Drive Marketing Dept. at (800) 872-2192
efesotomasyon.com -Toshiba inverter,drive,servo,plc
⇒
Program
Fundamental Parameters
⇒
Program
Fundamental Parameters
⇒
Standard Mode Set
⇒
Standard Mode Set
5