Ac Input Box Replacement Procedure; Tools; Preparation; Ac Input Box Removal Procedure - GE Vivid 4 BT03 RFI Service Manual

Table of Contents

2392751-100, R

AC Input Box Replacement Procedure

Use the appropriate flat and Phillips-type screw drivers and a wire cutter as indicated in the AC Input

Box replacement procedure.

Shut down the Vivid™ 4 ultrasound unit, as described in

1) Unplug the AC line power cable.

2) Remove the Vivid™ 4 left, right and rear covers, as described in the

3) Unplug the internal power cable from the AC Distribution Box.

4) Unscrew the Ground cable from the AC Distribution Box.

5) Remove the two screws on both the left and the right sides that secure the AC Input Box to the

6) Remove the AC Input Box.

1) Return the AC Input Box to its original position.

2) Tighten the two screws on both the left and the right sides that secure the AC Input Box to the

3) Tighten the screw that connects the Ground cable to the AC Distribution Box.

4) Reconnect the internal power cable to the AC Distribution Box.

5) Install the Vivid™ 4 rear, left and right covers, as described in the

on page 8 - 7 and the

on page 8 - 4, and the

Figure 8-69 AC Input Box Screws

Side Covers Installation Procedure

Section 8-6 - Lower Section Components Replacement

Rear Cover Removal Procedure

Installation.

Side Covers Removal

on page 8 - 7.

Rear Cover Installation Procedure

on page 8 - 4.