Pc-Vic Installation Procedure - GE Vivid 4 BT03 RFI Service Manual

GE M S
EDICAL YSTEMS
D 2392751-100, R
IRECTION
7.) Remove the PC-VIC.
8-5-14-4

PC-VIC Installation Procedure

1) Place a new PC-VIC in the PC-VIC module holder.
2) Return and tighten the four screws (two each side) on the side of the holder - refer to
Figure
3.) Reconnect all the cables at the rear of the PC-VIC module and the hard disk.
4.) Carefully slide the PC-VIC into position in the same location as that of the removed PC-VIC.
5.) Return and tighten the screw that holds the PC-VIC in position (as shown in
6) Return the BEP side cover as described in the
8 - 54.
7) Return the Vivid™ 4 left cover, as described in the
8-74
3
EVISION
Figure 8-57 PC-VIC Removal
8-57, above.
Section 8-5 - Back End Parts Replacement
BEP2 - Side Cover Installation Procedure
Side Covers Installation Procedure
V ™ 4 S M
IVID ERVICE ANUAL
Figure 8-56 on page 8-73).
on page
on page 8 - 4.