Switching Off And Retracting Power Cord; Transport And Storage - Silvercrest SMZS 1600 A1 Operation And Safety Notes

3 Operation
3.2 Switching off and
retracting power cord
17

3.3 Transport and storage

18
64
NOTE:
Your vacuum cleaner is equipped with a safety switch to
prevent overheating. It automatically cuts off the power
supply if the motor is overheated. In this case switch off
the vacuum cleaner with the on/off switch and pull the
plug from the mains socket. Eliminate the cause of over-
heating (e.g. clogged suction paths). Wait for about
45 minutes. After the appliance has cooled off, you may
switch it on again.
1. Switch off the cylinder vacuum cleaner with the on/off
switch (Fig. 17/1) and pull the plug from the mains sock-
et.
2. Keep the plug in your hand.
WARNING:
Danger of injury! During uncontrolled retraction the
power cord can whip around, become a tripping hazard
or knock over objects. Therefore, keep the plug in your
hand and guide it when retracting the power cord.
3. Push the cord retracting button (Fig. 17/2) to retract the
power cord.
To transport the cylinder vacuum cleaner you can car-
ry it by the handle (Fig. 1/9).
WARNING:
Danger of injury! Switch off the appliance when not work-
ing with it and observe the notices under

"Switching off and retracting power cord".

To park the appliance or during work breaks, you can
hang the parking hook into the parking hook holder
(Fig. 18).
It is recommended to first retract the telescopic tube.
ATTENTION:
Never store the appliance next to heat sources
(e.g. stoves or radiators). Avoid exposing it to direct sun-
light. Heat can damage the appliance.
Before storing the appliance for a prolonged period,
empty the dust container
container" and dispose of its contents properly.
Always store the appliance in a cool, dry place and out
of reach of children.
Chapter 3.2,
Chapter 4.1, "Emptying the dust