Hunt Groups (Hg); Hunt Group (Hg) And Call Group (Cg) Login And Logout - Siemens HiPath 1100 User Manual

Functions used when receiving calls
Step by step
qli
or
GP LOGON/GP LOGOFF
62

Hunt groups (HG)

The Hunt group (HG) feature allows you to configure ex-
tension groups which are then assigned for answering
calls directed to a specific number (up to 10 Hunt
groups, from 780 to 789).
When a group receives an incoming call, the call rings
at one extension at a time. If an internal or external call
is not answered after a specified timeout, it rings at the
next extension, and so on, until it is answered by an
available extension. The selection of an extension
where unanswered calls should ring is made in two dif-
ferent ways: linear or round-robin.
• A linear search always starts from the first extension
in the group.
• A round-robin search starts after the last extension
selected.
Calling a Hunt group (HG)
p
Enter the Hunt group number.
kld
•
w s
Wait for the call to be answered. Start conversation.
Hunt group (HG) and Call group (CG) Login
and Logout
Hunt group (HG) and Call group (CG) login and logout al-
low an extension to join or exit one or more of its groups
at any time.
Group login/logout
n
Lift the handset.
rli
Enter the code to Log in (ON) or Log out (OFF) of the
group. (*85 or #85)
or
Press the "GP LOGON/GP LOGOFF" key.
or
[1] See Programming an extension - Hunt groups (HG) - Search Mode
for Hunt groups, in the programming manual).
[2]Each member or non-member of the group is also accessible through
her/his extension number.
1
klm
to = Hunt groups (HG);
2