Alarms; Displaying User Alarms - Electrolux EWM09312 Service Manual

4

ALARMS

4.1 Displaying user alarms

When a problem arises in the appliance, which generates a "WARNING" or an "ALARM", this is displayed with
three digits, where normally the remaining cycle time is represented.
The alarms displayed to the user are listed below:
E10 - Water fill difficulty (tap closed)
E20 - Drain difficulty (filter dirty)
E40 - Door open
The alarms listed below:
EF0 – Water leakage (Aqua Control System)
For its solution, the intervention of a Service engineer is required
While for the alarm:
EH0 – Voltage or frequency outside normal values
It is necessary to wait for power supply voltage and/or frequency to restore normal conditions.
The alarms are enabled during the execution of the washing programme. With the exception of alarms
associated with the configuration and the power supply voltage/frequency, which are also displayed during the
programme selection phase.
The door can normally be opened (except where specified) when an alarm condition has occurred, on condition
that:
•
The level of the water in the tub is below a certain level.
•
The water temperature is lower than 55°C.
•
The motor has stopped.
Certain alarm conditions require a drain phase to be performed before the door can be opened for safety
reasons:
•
Cooling water fill if the temperature is higher than 65°C.
•
Drain until the analogue pressure switch is on empty, during a max. 3-minute interval.
Technical Support - A.D.L. 12/70 599 74 23-12 Rev.00